Low Profile Pneumatic Diesel Injector Puller with Handle

HU41056

Seized Diesel injector removal tool that combines the power of a slide hammer and the rapidity of a pneumatic tool
• Compact design allowing to use on most vehicles even when the firewall is in the way (47mm shorter than the competitors !)
• Comes with a handle to easily place and remove the puller on the injector and to hold the tool when the injector comes off, a
voi ding the puller to fall on the engine while still “hammering” and risking to damage expensive parts such as plastic intakes etc.
• Can also be used without the handle in case there isn’t enough room to fit it
• Handle is designed to avoid contact with the hand during use
• Can be set to work slowly with full stroke (hammering effect) or quickly with slightly shorter stroke (Vibrating effect) thanks to the ring
on the hammer
• Usual garage’s air pressure and air flow is sufficient for the tool to work 100%
Includes the adapters sizes M14, M17, M20, M25 and M27 (internal thread of the injector) to fit the
Denso, Siemens, Delphi and Bosch injectors